Home > Exhibition > Content
Absorber piston rod installation quality improvement approach
Dec 15, 2018

In order to improve the assembly quality of the entire system, after the Absorber piston rod is inspected and confirmed, the new sealant ring should be assembled while ensuring that the sealant ring is flat without distortion. And in this process, no oil should be adhered to prevent the rubber from becoming soft, and the elasticity is weakened and the sealing effect is lost. At the same time, an appropriate amount of sealant can be applied around the seal ring, and it should be continuous, uniform and uninterrupted when applied.

 

When installing the cylinder, pay attention to evenly apply the cylinder sleeve in place, and pay attention to check that each cylinder is higher than the upper plane height of the cylinder to avoid deformation or poor sealing of the cylinder head when tightening the cylinder bolt. If there are conditions, the cylinder head gasket and the cylinder head should be installed without leakage. Usually we are connecting the Absorber piston rod and the piston, so the connection is firm and should be locked carefully. There are also many problems due to wear and improper connection of the joints.

 

It should also be noted that it is important to ensure the quality of the seal during the connection of the Absorber piston rod. Since the piston seal is different from the Absorber piston rod seal, the gap size needs to be paid more attention during the sealing process.http://xhychromerod.com/